Download VM1548C - VTI Instruments
Transcript
VXI Technology, Inc. DEVICE TRANSFERS (READ MODE) When read transfers from the UUT are selected, the VM1548C will select the direction of the transfer, enable the clocks for the selected channel(s), latch the data into the I/O Data Buffer, if double buffering is selected, using the appropriate triggering method and clock the I/O Word Buffer. This clock, or trigger, can be from either a TTL trigger input, the front panel connector CLK input, a word serial event, or a TTL trigger out. The front panel connector CLK input will be used to trigger the latching of data into the I/O Data Buffer and then generate an Interrupt Request (IRQ) to the slot 0 controller. DIRECTION Direction of transfer is controlled either from the front panel connector or from the Direction Control latch (see Figure 5-3). Upon receipt of the SCPI command, the Timing and Control FPGA decodes the VMIP address and issues the DOE* signal to the Read/Write Data Buffer, allowing the data on the inputs to be available on the outputs when both signals are low. The Timing and Control FPGA then generates the PORTENA* signal that provides a low signal to the Port Decoder. Address bits A0, A1 and A2 are decoded, causing the Port Decoder to provide a low going edge clocking the Direction Control latch. This octal D latch provides the direction signal OUTENA0, a low equates to read and a high equates to write. This, then, is OR’ed with the corresponding I/O signal from the front panel connector. The front panel connector I/O signal is active low and is pulled to VCC through a 47 kΩ resistor. The signal is then inverted and routed to the OR gate. The result of OR’ing these two signals together provides a low on I/O Data Buffer direction enable lines GBA* and GAB. This signal is also routed to the I/O Word Buffer output write enable line OEAB1. This is done to avoid READ/WRITE contentions between the two buffers. The I/O buffers are now configured to receive data from the UUT or the read mode. CLOCK ENABLE Input clock enabling is accomplished when the VMIP module receives the SCPI command for input clock enable. The Timing and Control FPGA then decodes the address and control bits from the VMIP bus and generates the DOE* signal to the Read/Write Data Buffer. The Timing and Control FPGA generates PORTENA* enabling the Port Decoder as detailed previously. This time the address bits decode to PORT0* clocking the Read Clock Enable latch. The output of this latch CLKINENA0 is routed to the I/O Data Buffer clock enable line SBA. Loading of data into the I/O Data Buffer occurs when the VM1548C receives the appropriate input clock or trigger as specified by the SCPI command. 102 VM1548C Theory Of Operation