Download User Manual

When there is an alarm occurred in the e-map, the corresponding node becomes flashing
set alarm type and arm/disarm setup.
Item
1
. Please go to “Alarm Config” to
Note
Four direction buttons: Move e-map position
Center button: Move to the centre of the e-map. Please note this function is only valid when
you are zooming in the e-map.
2
Right button: Click it, system pops up the node information. Here you can view the e-map
organization and its node information.
3
On the right corner of the map:
+/-button: “zoom in”/”zoom out” e-map. You can roll down/up the middle button of the mouse
to realize these two functions.
4
Small e-map button: “Display”/”Hide” e-map. System hides the button when it is to display the
small e-map. You can left click the e-map to display the button again.
30