Download Manual - NSGate

qBRIDGE-100. Ethernet to G.703 Converter/Bridge
User’s Manual v.4
7
2. Device Configuration
2.1. Powerup
1. Configure qBRIDGE according paragraphs 2.2 – 2.7 of this manual.
2. Connect LAN port of the device to HUB/Switch or to a PC using a Patch Cord. Device supports auto-MDIX
therefore Patch Cords cable may be any type (cross or straight).
3. Connect WAN port (connector with “LINE” mark) to E1 channel. Use a cable with RJ–45 connectors.
4. Connect power adapter (DC 7÷12 V output) to the connector with “DC–IN” mark.
ATTENTION!
You must turn off the power of the device before making any DIP-switch configuration
changes. When configuration is complete turn the power on again.
2.2. LAN: Frame buffer configuration (SW1 .7– SW1.8)
qBRIDGE has internal RAM (Frame Buffer) to store Ethernet frames. The entire Frame Buffer capacity
is 340 frames. One part of the Frame Buffer is used to store frames passing from LAN to WAN port and the
second part is used to store frames passing from WAN to LAN port. To increase device performance user can
configure the way of dividing of the Frame Buffer. Use DIP-switches SW1.7-SW1.8 for this purpose.
SW1.7
on
on
off
off
SW1.8
on
off
on
off
LAN-to-WAN buffer capacity
308 packets
170 packets
32 packets
reserved
WAN-to-LAN buffer capacity
32 packets
170 packets
308 packets
reserved
2.3. LAN: Filtering mode (SW1.6)
qBRIDGE supports Real-time MAC-address filtering with 256 address table and Automatic address
learning and aging. If filtering is enabled, only broadcast, multicast and destined for remote LAN frames are
forwarded to WAN. The address table can store up to 256 MAC-addresses and is automatically updated. The
individual address will be aged and deleted from address table if frames with this address have not been
received within 5 minutes. User can enable or disable filtering using DIP-switch SW1.6.
SW1.6
on
off
Filtering
enabled (default value)
disabled
2.4. LAN: IEEE 802.3x flow control (SW1.5)
qBRIDGE provides IEEE 802.3x flow control for more effective packet forwarding. If the number of
packets buffered in memory exceeds the predefined value qBRIDGE transmits the PAUSE frame to pause the
data flow. When qBRIDGE receives the PAUSE frame it pauses the transmission until the requested time is
expired. User can enable or disable flow control support using DIP-switch SW1.5.
SW1.5
on
off
Flow control
enabled
disabled (default value)
NSGate