Download DataMite III Installation Tips

Sending Bytes via H12 Command Click on DataMite at top of main screen for this screen.
4) Click DataMite USB
Options, then Read Firmware
Version to bring up
Thermocouple Cal Info section
shown to right.
3) Click Current Readings to ensure
you can establish communications.
Once established, back out to this
DataMite Specs Screen
2) Click Find to find
possible Com Port,
then set to that port
5) Click Set Bytes for the Send Bytes
screen letting you enter the 4 bytes to
send via the H12 command
7) Click Download Bytes to send bytes in
proper command string and CRC to
logger board.
1) Set to DataMite 4
USB
6) Enter 4 bytes and click Keep Settings
DTM Instructions USB.pub page 57