Download bizhub PRO 1050e - Parent Directory

bizhub PRO 1050e
Perfect binder failure
PB-501, problem with UP/DOWN Unit.
Solution
Changes have been made to prevent the bearing for the Rotation Shaft/1 in the UP/DOWN Unit from falling off. Please refer to the attached Parts
Modification Notice for more information. To viewthe PDF, Adobe Reader® must be installed. Adobe Reader® can be downloaded for free from the Adobe®
web site at: http://www.adobe.com/products/acrobat/readstep2.html .
SPECIAL NOTE : Solution contribution by KMBT (Japan).
Solution ID
TAUS0802715EN*
Solution Usage
Description
PB-501, not recognized
Solution
CAUSE: The Perfect Binder has been isolated by isolation software dipswitches.
SOLUTION: Access software switch settings by entering Service mode, selecting System setting, selecting SoftwareSW setting. Use the arrows to scroll to
software switch 35-5 and set to 0 (OFF).
SPECIAL NOTE : Solution contribution by Bob Moeller, Production Print/SSD
Solution ID
TAUS0808417EN*
Solution Usage
Description
PB-501, Clamp Unit failure.
Solution
Modified parts are available to prevent Clamp Unit failure.A different type ofSupport Shaft screwisused. Please refer to attached Bulletin Number 6659 for the
details. To viewthe PDF, Adobe Reader® must be installed. Adobe Reader® can be downloaded for free from the Adobe® web site at:
http://www.adobe.com/products/acrobat/readstep2.html .
Solution ID
TAUS0808629EN*
Solution Usage
Description
PB-501, SC78-56 code will not clear after glue tank replacement.
Solution
CAUSE: Software Switch 3-1 is latched as a result of the temperature code.
SOLUTION: Reset Software Switch 3-1 to 0.
SPECIAL NOTE : Solution contribution by David Aekus, Production Print/SSD
Solution ID
TAUS0808660EN*
Solution Usage
Description
C-7834 during intialization of, or while running, the PB-501.
Solution
CAUSE: Possible damaged wiring or failure of motor M65.
SOLUTION: Reseat CN65 on the PBDB and inspect the wiring harness between CN65 and M65 for possible damage. If damaged wiring is found,replace the
wiring harness (p/n A075 N160 04), If no damage is found, replace M65 (p/n 15AA R736 00).
SPECIAL NOTE : Solution contribution by Chuck Tripp, Production Print/SSD
Copyright 2009, Konica Minolta Business Solutions U.S.A., Inc.
May 2009
150