Download IVC User`s Manual

Transcript
Video and Camera Connection Data
The next set of parameters to define for this camera (shown in Fig. 24) has to do with how the
camera communicates to the network.
Figure 24
Video Server
Every camera that will be connected to this video network has an IP encoder. This encoder may
be a separate device (as in the case of IP-enabling legacy analog cameras) or integrated with the
camera. In order for the Relay Server to communicate with this camera, it must know what type
of IP encoder (Video Server) it uses. You can find this information for the camera being
configured in the Camera Installation Guide shipped with the camera.
Custom Software
Leave as default unless directed otherwise by IVC Support.
Video Feed Host/ Video Feed Port
Enter the IP address and port number of this camera where indicated.
Video Control Host/Video Control Port
In rare cases for some PTZ cameras, the pan-tilt unit will have a different IP address than the IP
encoder. If your camera is configured in this way, enter the unique control IP address and port
number where indicated. Otherwise, enter the Video Feed Host IP address and port number in
these fields. Consult your Camera Installation Guide for more information.
RSS-4000 Series - Relay Server Guide
25