Download Yuma Quickstart Guide

Yuma Quickstart Guide
The following table shows some valid help commands:
command
3.5
description
help help
Get normal help for the help command.
help commands brief
Get a 1 line description of each command.
help object system full
Get all available help for the /system
container and all its descendant nodes.
help type NcxIdentifier
Get summary and description of the data
type called 'NcxIdentifier'.
help notification
sysSessionStart
Get a summary of the 'sysSessionStart'
notification, and each of objects in its
payload.
Start a NETCONF session
Each yangcli program instance can run 1 NETCONF session at a time.
If no session is currently active, then the prompt will contain just the program name, indicating that the
'connect' command is available:
yangcli>
3.5.1
THE
CONNECT
COMMAND
The 'connect' command is used to start a NETCONF session.
There are 3 mandatory parameters for this command:
•
user: the system (or SSH) user name to use
•
server: the IP address or DNS name of the NETCONF server to use
•
password: the password string to use
Make sure you have a user name and password already configured on the NETCONF server.
If a partial command is given, then yangcli will prompt for any missing mandatory parameters. In this
example, the complete command is given at once:
yangcli> connect server=localhost user=guest password=yangrocks
After this command is entered, yangcli will generate some informational log messages to the screen.
If the session is started successfully, a summary of the server session capabilities and available
modules should be displayed. Also, the command prompt will change to indicate that a NETCONF
session is currently active.
Page 13
Version 2.2