Download Topex Bytton User Manual

TOPEX Bytton (HSPA+ / LTE)
Marking Table
In this table, which is empty at first, each entry must specify the direction (IN or OUT), the source or
destination IP and corresponding Net mask, the protocol (either TCP, UDP or all), Type of Service (TOS)
enabling or not and corresponding TOS match, TOS marking (enable or disable) and corresponding TOS
value:
Each record in the marking table may be individually deleted or edited
Figure 5-137: Editing the QoS Marking table
When you finished entering TOS marking and matching values,
use the general Save, the long button called “Save and Reload”
located at the bottom of the page:
ByttonLTE(full)_genericUsermanual_sw306FAS_revN.1.docx
Page: 204 / 290
www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299