Download CP 340 Manual

Transcript
Basic Principles of Serial Data Transmission
Receive Buffer on
CP 340
Table 2-9
The table below describes the parameters for the CP receive buffer.
Receive Buffer on CP (ASCII Driver)
Parameter
Description
Value Range
Default Value
Delete CP receive
buffer at start-up1
Here you can specify whether the CP
receive buffer is to be deleted during
start-up, or whether an existing (old)
message frame is to be passed on to the
CPU.
• yes
• no
• yes
Buffered receive
message frames1
Here you can specify the number of receive message frames to be buffered in
the CP receive buffer.
1 to 250
250
• yes
• no (only if ”buff-
• yes
If you specify ”1” here and deactivate
the following parameter ”prevent overwrite” and cyclically read the received
data from the user program, a current
message frame will always be sent to
the CPU.
Prevent overwrite
1
You can deactivate this parameter if the
parameter ”buffered receive message
frames” is set to ”1”. This authorizes
the buffered receive message frame to
be overwritten.
ered receive message frames” =
”1”)
If several message frames are buffered, the CP 340 always sends only the oldest to the CPU (ring buffer)
Further
Information
2-48
In Section 2.2.3 you can find further information on handling the receive
buffer under “Receive Buffer on CP 340”.
CP 340 Point-to-Point Communication
ASE00053578-05