Download H18 AT Command User Guide

ERROR
if value is not recognized or not supported.
An OK result code for this command is issued using the same rate, parity, and
format as the DTE command line containing the command, but using the
factory-defined values for other parameters that affect the format of result
codes (e.g. Q, V, S3, S4) and dependent upon other commands that may
follow on the same command line.
Informative Examples
- Initial the HyperTerminal
- Initial the MS
- AT Command
AT&F
OK
AT&F0
OK
AT&F1
ERROR
AT&F2
EXT: I
ERROR
2.2.1.4 Request identification information (I)
Table: Syntax ( I )
Command
Possible response(s)
I
Description
This command causes the DCE to transmit one or more lines of information
text, determined by the manufacturer, followed by a final result code. <value>
may optionally be used to select from among multiple types of identifying
information, specified by the manufacturer.
NOTE – The responses to this command may not be reliably used to
determine the DCE manufacturer, revision level, feature set, or other
information, and should not be relied upon for software operation. In particular,
expecting a specific numeric response to an I0 command to indicate which