Download CAUTION - TrekDesk

Step One:
-Place Left and Right Desk Tops (1 & 2) upside down on a hard FLAT surface (not carpet) to
insure that both halves are lined up evenly (this is very important).
Step Two:
-Place Desk Support Braces (6) as shown below positioning into the pre-molded grooves. First
affix the Braces in rows A, C, & D with Assembly Screws with your power drill. Be careful to
insure that desktop halves remain lined up evenly. Secure row B with Assembly Screws last with
the exception of 3 holes in center (marked in RED in the below photo). Leave these three screw
holes vacant until the next step.