Download - Panimac srl

Initial Settings
Tilting head cut at intermediate angles
In case you need to make cuts inclination between 45 ° and 90 ° follow these steps:
Select the cutting mode “0” and start operation:
•
•
•
•
•
•
Operate the switches for tilt your head at 45 °
Release the "c " lever
Place the reference pin reading the angle on the graduate scale "e"
Lock the "c" lever
Re-apply selectors inclination to move the head to the desired gradation
To restore the standard angles steps again by moving the lock bolt against the stop of 90 °
e
c
d
NOTE: Unlock the “c” lever only when the heads are inclined at 45 °
Tilting head cut at 22.5 °
In case you need to make cuts to 22.5 ° inclination:
Select the cutting mode “0” and start operation:
•
•
•
•
Operate the switches for tilt your head at 90°
Turn the knob "d" to delete batting 45 °
Re-apply selectors inclination to move the head to 45 °
To restore the standard angles steps again by moving the head to 90 ° and restore the beats of the
45 °