Download User`s Manual
Transcript
Precautions Concerning Installation Location Product Overview The PMX Series is a lineup of easy-to-use, compact regulated DC power supplies. It can be controlled remotely through the standard-equipped communication feature. Model Maximum operating current Maximum operating voltage Power PMX18-2A 2A 18 V 36 W PMX18-5A 5A 18 V 90 W PMX35-1A 1A 35 V 35 W PMX35-3A 3A 35 V 105 W PMX70-1A 1A 70 V 70 W PMX110-0.6A 0.6 A 110 V 66 W PMX250-0.25A 0.25 A 250 V 62.5 W PMX350-0.2A 0.2 A 350 V 70 W PMX500-0.1A 0.1 A 500 V 50 W When installing this product, be sure to observe the “Precautions Concerning Installation Location” in the Safety information manual. The following precautions pertain only to this product. • When installing this product, be sure to observe the temperature and humidity ranges indicated below. Operating temperature range: 0 °C to +40 °C (32 °F to 104 °F) Operating humidity range: 20 %rh to 85 %rh (no condensation) • When storing this product, be sure to observe the temperature and humidity ranges indicated below. Storage temperature range: -25 °C to +70 °C (-13 °F to 158 °F) Storage humidity range: 90 %rh or less (no condensation) Notations Used in This Guide • In this manual, the PMX Series Regulated DC Power Supply is referred to as the “PMX Series” or “PMX.” Features • The term “PC” is used to refer generally to both personal computers and workstations. Communication feature • The screen captures used in this manual may differ from the actual screens that appear on the PMX series. The screen captures are merely examples. RS232C, USB, and LAN interfaces are all installed as standard. The remote interfaces comply with IEEE Std 488.2-1992 and SCPI Specification 1999.0. Because the LAN interface complies with the LXI standard, the construction of a highly cost-effective system is possible. Setting preset feature You can save up to three sets of output settings (the combination of the voltage value and current value). You can simply select a set of output settings that you want to use rather than having to specify each setting every time. External control External analog signals can be used to control the output voltage and current, turn the output on and off, and monitor the operation mode. Remote sensing (equipped on models whose rated output voltage is 18 V or 35 V) Remote sensing stabilizes the output voltage across the load by reducing the influence of voltage drops and other effects caused by the load cable resistance. • The following markings are used in the explanations in this manual. WARNING Indicates a potentially hazardous situation which, if ignored, could result in death or serious injury. CAUTION Indicates a potentially hazardous situation which, if ignored, may result in damage to the product or other property. Indicates information that you should know. DESCRIPTION Explanation of terminology or operation principle. See Indicates a reference to detailed information. Standard protection functions The PMX series is equipped with standard overvoltage protection (OVP), overcurrent protection (OCP), and overheat protection (OHP) functions. When a protection function is activated, the cause of it is indicated on the front panel display area. The output is turned off to protect the product and the load. Safety Precautions When using this product, be sure to observe the “Safety Precautions” in the Safety information manual. Indicates a reference to a manual containing detailed information. CFxx:x “CF” indicates that this is a CONFIG parameter. The two digits after CF indicate the CONFIG parameter number. The value after the colon indicates the selected setting. SHIFT+key name (blue letters) Indicates an operation that requires you to press a key indicated in blue characters (below the key) while holding down the SHIFT key. Memo Indicates useful information. PMX 3