Download FC3600 - Graphtec

4.26 Specifying the Initial Cutting Force (When Using the Cutter Pen)
In some cases in which thick media is cut, cut marks are left on the medium at the start point when cutting
is started before the cutter blade reaches the bottom of the medium, even if the required cutting force is
applied. After blade tip control has started (at the start of cutting or cutter blade rotation), additional initial
cutting force can prevent cut marks by ensuring that the cutter blade reaches the bottom of the medium.
Specify higher values for greater cutting force. Note that the initial cutting force is a supplemental cutting
force added momentarily to the cutting force specified in the conditions.
(Default value: 4)
1.
Press the
PAUSE key to put the FC3600 offline.
2.
Press the
NEXT PAGE key repeatedly until the following menu is displayed.
OFFSET
FORCE
F1
F2
3.
Press the
F4
KEY OPT. TOOL COND
OPTION1
OPTION2
SPEED
QUALITY
F2
4.
Press the
F1
OFFSET
START FCE DIST ADJ
L UNIT
TEST
SPEED
QUALITY
F3
F4
key (START FCE) to display the settings menu for initial cutting force.
OFFSET
FORCE
F1
F2
F4
key (OPTION2) to display the menu shown below.
FORCE
F1
F3
F3
START CUT FORCE
FORCE = 10
SPEED
QUALITY
F4
5.
Use the
or
POSITION key to increase or decrease the value in the range from 1 to 20. Press
the
ENTER key upon completing the settings. To cancel setup, press the
NEXT PAGE key.
6.
Press the
PAUSE key to put the FC3600 online again.
4 – 51