Download for FE-Sizer Version 3.0 User`s Manual - Control
Transcript
Section 4 - User Interface Types and Descriptions 4.2.4 Fluid Input Fluid Data - sets input focus to the first item of the Fluid Data section of the main screen. Calculate Fluid Properties... - pop-up menu for selecting the fluid correlation used to estimate the fluid properties. Gases & Vapors - dialog to setup sizing equation for gas and flows. Liquids - dialog to setup sizing equation for liquids. 4.2.5 Sizing Input Sizing Data - sets input focus to first item of the Sizing Data section of the main screen. Calculation Setup... - dialog to select the sizing parameter and calculation modes. Calculate Sizing Parameter - command to calculate sizing parameter based on user supplied input data. 4.2.6 Factors M anometer... - dialog for setup of factor for correcting the indicated differential for the effects of a gas or liquid leg of fluid at static pressure and temperature at the instrument for mercury U-tube manometers and mercury-manometer-type differential pressure instruments. Drain/Vent Hole... - dialog for setup of factor adjusting the calculation for the increased flow through a drain or vent hole. W ater-Vapor Correction... - dialog for setup of factor converting a given volume of gas flow to a condition of moisture content other than that corresponding to flowing conditions - enabled only for gases and vapors; grayed or disabled for any other fluid. Saturated Liquid... - dialog for setup of factor correcting calculation for saturated liquid flows where the vapor quality (percentage of vapor mass to total fluid mass) is 10 percent or less - enabled for all liquids; grayed or disabled for all gases and vapor fluids. Quality... - dialog for setup of factor correcting calculation for saturated vapor flows where the vapor quality is 90 percent or more - enabled vapor mass flow fluids; grayed or disabled for all other fluids. 4.2.7 M eter/Pipe M eter Type - pop-up menu for selecting meter type, e.g., orifice, flow nozzle, venturi, etc. Pipe Data... - dialog for setup of pipe data, i.e., inner diameter, schedule, etc. 4.2.8 Base... Activates dialog to set base condition data, i.e., base temperature and pressure, atmospheric pressure, etc. 4.2.9 Utility Flow Units Setup - dialog for setting and defining various flow units. User - pop-up menu where you can select to enter user, company and customer data. Uncertainty... - dialog for setting and defining the various uncertainty or accuracy input values. 15