Download TEX300 LCD

TEX300-LCD
To change the set power level press the ENTER push button until it enters the
modification mode.
The screen that is shown in the modification mode is similar to the following:
The bottom line gives the instantaneous reading of the power (297W in this example),
whereas the bar indicates the set level. To increase the level, press the LEFT/UP
push button and to reduce it, press RIGHT/DOWN . When the desired level is
reached, press ENTER to confirm and exit the predefined menu. Note that the set
value is stored anyway, so if you press ESC or let the timeout go by without pressing
a key, the power will remain at the last set level.
If you press the ESC push button while you are in the predefined menu, you will be
shown the following selection screen from which you can access all the other menus:
To enter one of the submenus, select its name (which will be underlined by a blinking
cursor) with the RIGHT or LEFT push buttons and then press the ENTER push button.
If you instead want to go back to the predefined menu, all you have to do is press the
ESC push button again..
Nel caso che l’allarme di temperatura fosse abilitato, al superamento della soglia di
allarme verrà visualizzata la seguente schermata:
NOTA: Questa schermata sarà visualizzabile solo se si è nella schermata predefinita.
User Manual
Rev. 0.1- 04/02/05
9 / 26