Download MXI-2 Configuration Reference Manual

Transcript
Chapter 5
VXI-MXI-2 Configuration and Installation
Switches S8 and S9 on the VXI-MXI-2 select its position in relation to
any other VXI-MXI-2 module in the chassis. Use switch S9 when there is
a VXI-MXI-2 to the right (higher-numbered slot). Use S8 when there is a
VXI-MXI-2 to the left (lower-numbered slot).
Figure 5-11 shows four configuration settings for a VXI-MXI-2.
Figure 5-11a illustrates the default setting, which is for a single
VXI-MXI-2 in a chassis. Use the setting in Figure 5-11b for the
VXI-MXI-2 located to the left of all others. Figure 5-11c shows the setting
to use if the VXI-MXI-2 is between two others. Use the setting of
Figure 5-11d for the VXI-MXI-2 located to the right of all others.
S8
S8
S9
No
S9
Yes
No
VXI-MXI to left
VXI-MXI to left
VXI-MXI to right
VXI-MXI to right
Yes
b. Leftmost VXI-MXI-2 in Mainframe
a. Single VXI-MXI-2 in Mainframe (Default)
S8
S8
S9
No
S9
Yes
No
VXI-MXI to left
VXI-MXI to left
VXI-MXI to right
VXI-MXI to right
c.VXI-MXI-2 between Two Others
Yes
d. Rightmost VXI-MXI-2 in Mainframe
Figure 5-11. VXIbus Local Bus Configuration
Install the VXI-MXI-2
This section contains general installation instructions for the VXI-MXI-2.
Consult your VXIbus chassis user manual or technical reference manual for
specific instructions and warnings.
1.
© National Instruments Corporation
Plug in your chassis before installing the VXI-MXI-2. The power cord
grounds the chassis and protects it from electrical damage while you
install the module.
5-17
MXI-2 Configuration Reference Manual