Download MXI-2 Configuration Reference Manual
Transcript
Chapter 5 VXI-MXI-2 Configuration and Installation Switches S8 and S9 on the VXI-MXI-2 select its position in relation to any other VXI-MXI-2 module in the chassis. Use switch S9 when there is a VXI-MXI-2 to the right (higher-numbered slot). Use S8 when there is a VXI-MXI-2 to the left (lower-numbered slot). Figure 5-11 shows four configuration settings for a VXI-MXI-2. Figure 5-11a illustrates the default setting, which is for a single VXI-MXI-2 in a chassis. Use the setting in Figure 5-11b for the VXI-MXI-2 located to the left of all others. Figure 5-11c shows the setting to use if the VXI-MXI-2 is between two others. Use the setting of Figure 5-11d for the VXI-MXI-2 located to the right of all others. S8 S8 S9 No S9 Yes No VXI-MXI to left VXI-MXI to left VXI-MXI to right VXI-MXI to right Yes b. Leftmost VXI-MXI-2 in Mainframe a. Single VXI-MXI-2 in Mainframe (Default) S8 S8 S9 No S9 Yes No VXI-MXI to left VXI-MXI to left VXI-MXI to right VXI-MXI to right c.VXI-MXI-2 between Two Others Yes d. Rightmost VXI-MXI-2 in Mainframe Figure 5-11. VXIbus Local Bus Configuration Install the VXI-MXI-2 This section contains general installation instructions for the VXI-MXI-2. Consult your VXIbus chassis user manual or technical reference manual for specific instructions and warnings. 1. © National Instruments Corporation Plug in your chassis before installing the VXI-MXI-2. The power cord grounds the chassis and protects it from electrical damage while you install the module. 5-17 MXI-2 Configuration Reference Manual