Download GA10 Data Logging Software User`s Manual
Transcript
Chapter 3 Configuring and Starting Data Collection and Recording 3.2 E asy Configuration (Simple Settings) This section explains how to configure the settings in Simple Settings mode before starting data collection. To customize the settings and start data collection: page 3-4 3.2.1 Creating a Project 1 2 3. Start GA10, and log in by typing the user name and password. On the File menu, click New Project. The Create New Project dialog box appears. Note 3 4 For details on where the Ethernet port is located and the hierarchy of setting menus, see the user’s manual of the relevant device. Check that the PC and the device have been connected. You can check the connection using Windows Device Manager or from the command prompt. Register the DX on the network in GA10. Doubleclick the project that you created in section 3.2.1. The Simple Settings page opens. Type the project name and comment. Leave Settings Mode at Simple Settings. Click OK. Leave this at Simple Settings. Type the project name and comment. 5 A new project is created. Click Search in the Online Devices List on the right side of the page. Devices connected to the network are detected and displayed. Click Search. 3.2.2 Registering Devices to Connect To register devices to the new project, you must connect the devices to the network. Below is an example of connecting a DX to the PC through the Ethernet interface. 1 Connect the device and the PC through a network using LAN cables. 6 Drag & drop the icon of the device that you want to register to the Device List on the left side of the page. PC HUB 2 Ethernet * The figure shows a one-to-one connection. Configure the Ethernet settings on the device. Set the device’s IP address and subnet mask. On the DX Press MENU, hold down FUNC for 3 s (to switch to basic setting mode), and select the Menu tab > Communication (Ethernet). 3-2 In the center of the page, a window appears showing the details of the device that you are about to register. IM 04L65B01-01EN