1
Download Manual - Extech Instruments
Transcript
Overtime Trigger: In Pulse Width trigger mode, it may take some time for a trigger to occur. Since a complete pulse width is not needed to trigger the oscilloscope, it may be desired to trigger just upon the overtime point. This is called Overtime Trigger. Press on TRIG to enter Trigger mode. Options Type Source (F2) Polarity (F3) Settings CH1 CH2 Positive Negative Normal Mode (F4) Comments O.T. Auto Single Page (F5) Select channel to source the trigger Select to trigger on positive or negative pulses. Select the type of trigger. The Normal mode is best for most applications. Change page from 1 to 2 Overtime (F2) Adjust timing using the Multifunction control. (menu page 2) AC Coupling (F3) (menu page 2) DC HF Reject LF Reject Selects the components of the trigger signal applied to the trigger circuitry. Noise Reject 50% (F4) Page (F5) Change page from 2 to 1 44 MS6000-EU-EN V1.4 8/12
