Download OPTIBOARD CONTROLLER BOARD USER MANUAL

Transcript
SET LINE SPACING
Sets the line spacing to n/406 inch (n/16 mm).
The minimum line spacing is 8.5 lines per inch. The line spacing equals the character height when n is too
small.
If the Set Horizontal and Vertical Minimum Motion Units command (1D 50) is used to change the
horizontal and vertical minimum motion unit, the parameters of this command (Set Line Spacing) will be
interpreted accordingly.
Value of n
Range of n
Default
ASCII
ESC 3 n
Hexadecimal 1B 33 n
Decimal
27 51 n
n/406 inch
0-255
0.13 inch (3.37 mm)
Related Information
For more information, see the description of the Set Horizontal and Vertical Minimum Motion Units
command in this document.
PRINT AND FEED PAPER
Prints one line from the buffer and feeds the paper n/203 inch (n/8 mm). The line height equals the
character height when n is too small.
If the Set Horizontal and Vertical Minimum Motion Units command (1D 50) is used to change the
horizontal and vertical minimum motion units, the parameters of this command (Print and Feed Paper) will
be interpreted accordingly.
Value of n
Range of n
ASCII
ESC J n
Hexadecimal 1B 4A n
Decimal
27 74 n
n/203 inch
0-255
Related Information
For more information, see the description of the Set Horizontal and Vertical Minimum Motion Units
command in this document.
PRINT AND FEED N LINES
Prints one line from the buffer and feeds paper n lines at the current line height.
ASCII
ESC d n
Hexadecimal 1B 64 n
Decimal
27 100 n
Range of n
1-255 (0 is interpreted as 1)
OPTIBOARD CONTROLLER BOARD User Manual
Page 45 /132
Reference: FDE 3106896 Issue Z