Download Renesas Flash Programmer V2.05 Flash memory programming

Renesas Flash Programmer V2.05
2.4.3
CHAPTER 2 FUNCTION DETAILS (BASIC MODE)
[Microcontroller] menu
The following pull-down menu appears by selecting the [Microcontroller] menu. This menu is used for selection and
setting of commands such as disconnection from a device, all erase, and program. If you select a command, the check
mark is displayed at the left of the command, and the command is assigned to the Start button. Note that [Disconnect
from Device] and [Set Project] commands are not assigned to the Start button.
Figure 2-26. [Microcontroller] Menu
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(1) [Disconnect from Device]
This command is used to disconnect from the device, and shut off the power supply if the [Power target from the
emulator] check box is selected in the [Power Supply] dialog box.
(2) [Blank Check] command
This command executes blank check on all areas of the flash memory. The result is displayed per area when the
command completes.
(3) [Erase] command
This command is used to erase the specified block of the flash memory. Executing the [Erase] command opens the
[Erase] dialog box. The blocks whose checkboxes are selected will be erased.
R20UT2909EJ0201 Rev. 2.01
Apr 01, 2015
Page 34 of 73