Download Technical Manual TNC 360
Transcript
7 4 PLC Modules A range of PLC Modules is available for certain PLC functions that cannot be performed with the PLC commands, or only in a complicated way. They are described below in more detail. 4.1 Module 9000: Copy a marker block Module 9000 can be used to copy a block with a certain number of markers, beginning with the start address, in ascending order to another marker range, beginning at a certain target address. Care must be taken that the blocks do not overlap, and that there is adequate space for the copied block after the target address. Module call: PS K/B/W/D PS K/B/W/D PS K/B/W/D CM 9000 1st Marker of the block to be copied (start address) 1st Marker of the target address for copying Length of the marker block If the block is not copied correctly, marker M3171 will be set. 4.2 Module 9001: Copy a Word block Module 9001 can be used to copy a block with a certain number of Bytes, Words or Doublewords, beginning with the start address, in ascending order to another area, beginning at a defined target address. The length is always given in Bytes. Care must be taken that the blocks do not overlap, and that there is adequate space for the copied block after the target address. Module call: PS K/B/W/D PS K/B/W/D PS K/B/W/D CM 9001 1st Byte of the block which is to be copied (start address) 1st Byte of target address for copying Length of the block in Bytes If the block is not copied correctly, marker M3171 will be set. 8/95 TNC 360 4 PLC Modules 7-103
Related documents
Technical Manual TNC 407, TNC 415 B, TNC 425
ElektronikNytt.com
User's Manual TNC 406, TNC 416
Technical Manual TNC 116 up to NC Software: 246
Technical Manual TNC 122
Special price
Service Manual TNC 306, TNC 360
User's Manual TNC 122
Modo de empleo TNC 122
Compaq EVO N410C User's Manual
MP3XXX User Manual _English_
Service Manual - Manuales de Service