1
Download Technical Manual TNC 360
Transcript
kv factor Adjust the kv factor (MP1810) so that the voltage characteristic is as described in Section "Servo positioning". If a different kv factor is required for rapid traverse to that for the machining feed rate, it must be optimized separately. Optimize kv factor for the machining feed rate (X axis) Connect storage oscilloscope to tachometer of the servo-amplifier of X axis. Enter following program in "PROGRAMMING AND EDITING" operating mode: LBL 1 X 1001) R0 F2)... X 0 R0 F2)... CALL LBL 1 REP 100/100 Press machine START button in the "PROGRAM RUN/FULL SEQUENCE" operating mode. Machine runs. Note: Set feed override to 100%. MP1810: Increase entry value until position loop oscillates or until an overshoot occurs after the acceleration ramp. U [V] ➀ t [s] ➀ Machining feed MP1810 (kv factor): Reduce entry value until no oscillations are detectable. U [V] t [s] Repeat adjustment for axes Y, Z, and IV. 1) Program the traverse paths for the axis concerned as large as possible. Enter the max. feed rate for machining. For axes which are mutually interpolated the kv factor must be the same. In this case the worst axis determines the entry value. 2) 4-234 TNC 360 16 Commissioning and Start-up Procedure 8/95
