Download HERA User Manual

Transcript
Figure 3: HERA beam pattern at the telescope focal plane in the Nasmyth
cabin, viewed from the receiver. The derotator is at its default position (set
derot 0 F). This is not the sky pattern !
The possibilities to focus HERA are quite similar to the pointing options. There is no difference to single beam receivers for focusing onto the
central element, and one uses the OBS command set recoff to focus on
off–elements.
To focus on off–center pixel No. n, e.g. because it is more stable in
continuum than the center pixel, one goes through the following sequence
of OBS commands:
set derot 0 F
set recoff xn yn
focus n
corr * * F
(if fit is satisfactory)
set recoff 0 0 (reset pointing offset for central pixel)
Remark: The focus procedure of the 30m telescope has shown some odds
recently. It is not unusual to have from time to time unsatisfactory focus
fits which would result in very big offsets. HERA has been proven to focus
very closely to the position of the other SIS receivers. Do not simply correct
for proposed focus offsets of more than 2mm, but double check these results
with another focus observation.
8