Download Downloaden

WD-100GR
Rev. 3.0 (201205)
Instructions for use
4.3.4
Operating problems
Troubleshooting
PROBLEM
CAUSE
ACTION
No indication on the control
panel display when the control button is pressed.
The machine does not fill with
water.
The mains switch is off.
Turn on the mains switch.
The stopcock on the incoming water supply is closed.
The doors are open.
The level pipe is not in place.
The level pipe's rubber
sleeve is not sealing against
the bottom plate.
The doors are not closed.
Open the stopcock.
Object preventing one door
from closing.
Remove the object.
Low water level. Foam in the
tank.
The rinsing and washing nozzles are clogged with dirt.
There is too little detergent.
Check the level. Change the
water.
Check and clean the nozzles.
The tanks overfill.
The machine does not start
washing.
The display indicates that the
anti-crushing mechanism
has been triggered.
Noise from the wash pump.
The machine is not cleaning
properly.
The wrong wash programme.
The water in the tanks is too
dirty.
There is too little granulate in
the tank.
Granulate sticks to the
washed items.
The granulate is in the wrong
tank.
The doors are sticking.
The washed items do not dry.
The removable parts are incorrectly fitted.
The rinse nozzles are
blocked.
There is too much foam in the
machine.
There is too much foam in the
machine.
The wash water is too dirty.
Very worn granulate.
Detergent concentration too
high.
Granulate in the tracks for the
doors.
The rinse nozzles are
blocked.
50
Close the doors.
Fit the level pipe.
Check that the level pipe is
closed. Change the rubber
sleeve if it is damaged.
Close the doors.
Check that there is sufficient
detergent in the machine.
Choose a programme with a
longer washing time.
Change the water.
Check the amount of granulate and add more if necessary.
Fit the parts correctly.
Clean the nozzles.
Check to see how clean the
wash water is. Change the
water if necessary.
Check to see how clean the
wash water is. Change the
water if necessary.
Change the water.
Replace the granulate.
Reduce the amount of detergent.
Open and close the doors a
few times.
Check and clean the nozzles.