Download Double-Take Availability for Hyper-V User`s Guide

Replica Virtual Machine Network Settings
If your virtual machine is powered on and has Integration Services available, this option will allow
you to configure advanced settings, which are used primarily for WAN support. Before you can
set these options, you must provide credentials for the virtual machine you are protecting. Click
the link Provide credentials and specify the Guest Host name, User name, Password,
Domain, and click OK
l
l
Use advanced settings for replica virtual machine network configuration—Select
this option to enable the replica virtual machine network setting configuration.
Network adapters—Select a network adapter from the source and specify the Replica
IP addresses, Replica Default Gateways, and Replica DNS Server addresses to be
used after failover. If you add multiple gateways or DNS servers, you can sort them by
using the arrow up and arrow down buttons. Repeat this step for each network adapter on
the source.
Updates made during failover will be based on the network adapter name when
protection is established. If you change that name, you will need to delete the job
and re-create it so the new name will be used during failover.
If you update one of the advanced settings (IP address, gateway, or DNS server),
then you must update all of them. Otherwise, the remaining items will be left blank.
If you do not specify any of the advanced settings, the replica virtual machine will be
assigned the same network configuration as the source.
By default, the source IP address will be included in the target IP address list as the
default address. If you do not want the source IP address to be the default address
on the target after failover, remove that address from the Replica IP addresses
list.
Chapter 3 Creating an agentless Hyper-V job
21