Download CD Device - Sager Notebooks

Troubleshooting
Win98SE Installation
Warning
Win98SE
installation
usually requires you to
start your system from
a floppy disk, then
browse to the CD to run
setup.exe program. After the system has
started up from the floppy disk, please disconnect the USB floppy
drive before browsing
to the CD drive to install
the Win98 software.
This will avoid a “system hang”.
7
7 - 32
Operation
The system freezes.
possible cause:
indicator:
solution:
possible cause:
solution:
The system’s power saving features have
timed-out.
The screen goes dark.
Use the AC adapter, press the Fn + F4 (suspend/resume) key combination, or press the
power button if no LEDs are lit.
A software conflict made the system “crash”.
Consult your OS manual. As a last resort, since
you will lose any unsaved data, try to reboot
the system or if that doesn’t work, turn the
computer off and on again.
The system never goes into hibernate mode.
possible cause:
solution:
Power Options features are not enabled.
Go to the Power Options control panel and
enable the features you prefer (see “Enabling
Power Options” on page 3 - 18).