Download User`s Manual 10.97 8-Bit CMOS Microcontroller http
Transcript
On-Chip Peripheral Components C504 Capture/Compare Channel Mode Select Registers The capture/compare channels of the CAPCOM unit can operate individually either in compare mode or in capture mode. The CMSEL0 and CMSEL1 registers contain the mode select bits for the CAPCOM unit. Special Function Register CMSEL0 (Address E3H) Special Function Register CMSEL1 (Address E4H) Bit No. MSB 7 E3H 6 5 4 3 2 1 LSB 0 CMSEL CMSEL CMSEL CMSEL CMSEL CMSEL CMSEL CMSEL 12 11 13 02 01 00 10 03 CAPCOM Channel 1 7 E4H Reset Value : 00H Reset Value : 00H 6 ESMC NMCS CMSEL0 CAPCOM Channel 0 5 4 0 0 3 2 1 0 CMSEL CMSEL CMSEL CMSEL 23 22 21 20 CMSEL1 CAPCOM Channel 2 Bit Function ESMC Enable software controlled multi-channel PWM modes If ESMC=0, switching of the follower state in 4-/5-/6-phase multi-channel PWM mode is controlled by compare timer 1 reaching its period value. If ESMC=1, switching of the follower state in 4-/5-/6-phase multi-channel PWM mode is controlled by bit NMCS. NMCS Next multi-channel PWM state Setting bit NMCS (with ESMC set) will select the follower state in the 4-/5-/6phase multi-channel PWM mode, which is taken into account at the output pins, when compare timer 1 is 0. Bit NMCS is reset by hardware in the next clock cycle after it has been set. CMSELx3 x=0-2 Switching compare timer 2 output signal to COUTx If CMSELx3 is set and compare mode is selected for the outputs COUTx, the output signal of the 10-bit compare unit, typically a higher frequency signal, is switched (modulated) to the COUTx pin. The state of the corresponding COINI bit at the start of compare timer 1 defines the logic level of the CAPCOM channel output signal at iwhich the COMP output signal is output to COUTx. COINI is set : The COMP output is switched to COUTx during the low phase of the CAPCOM channel X signal. COINI is cleared : The COMP output is switched to COUTx during the high phase of the CAPCOM channel X signal. Semiconductor Group 6-51 1997-10-01