Download User Manual - SuperMax Tools

Troubleshooting Your SuperBrush 
Troubleshooting Guide: Conveyor
PROBLEM
POSSIBLE CAUSE
SOLUTION
Conveyor rollers run
intermittently.
1. Shaft coupling loose.
Align shaft flats of gear motor
and drive roller; tighten shaft
coupling set screws.
Conveyor belt slips
on drive roller.
1. Improper conveyor belt
tension.
Adjust belt tension (page 8).
2. Excessive depth of cut.
Reduce depth of cut;
reduce feed rate.
1. Excessive depth of cut.
Reduce depth of cut.
2. Tension rollers too high.
Lower tension rollers (page 9).
3. Excessive feed rate.
Reduce feed rate.
4. Dirty or worn conveyor
belt.
Clean or replace conveyor
belt.
1. Belt out of adjustment.
Readjust belt; (page 8).
2. Drive or driven conveyor
belt rollers misaligned.
Readjust
3. Conveyor table not flat
and square.
Readjust by leveling
machine
4. Conveyor belt worn.
Replace conveyor belt (page 19).
5. Drive roller worn
or damaged.
Replace drive roller.
6. Roller bushings elongated
due to excessive wear.
Replace bushings.
Stock slips on
conveyor belt.
Conveyor belt tracks
to one side, or oscillates
from side to side.