Download Programmable DC Electronic Load

PEL-2000 Series User Manual
Positive and
Negative
Terminals Right
For 2 channel load modules, the left
terminals are used for the 1st
channel and the right terminals are
used for the 2nd channel.
On single channel load modules,
the left terminals are the lower (-)
potential terminals, whilst the right
terminals are the positive (+)
potential terminals.
Static/Dynamic
Selector Key
The STATIC/DYNA. Key manually
switches the load from Static
(manual) to Dynamic loads.
Dynamic loads are only supported
in CC and CR mode.
For more information see page 61 &
65.
Selector Knob
(Load)
The load Selector Knob is used to
edit and vary parameters for the
active channel on the local load.
Depending on the Mainframe
setup, the Selector Knob will either
only update the load (locally) or
will update both the local module
and the mainframe*. The Selector
knob can also be configured to
display measured or set values on
the local load module**.
* For more information on “Knob Type”, see
page 188.
** For more information on “Slave Knob”,
see page 192.
30