Download User Manual

KSI User Manual
Page 54
Chapter Six—Programming
Introduction
In addition to the programming information relating to time data given in this
manual, there are command codes for triggering the TPRO-VME to add latitude,
longitude and elevation data in the FIFO buffer.
Register Map
Table 6.1—Addressing Base: A6 to A31 Configurable by Wire Wrap
Offset 1
D08/D16 MC68153 control register 0
Offset 3
D08/D16 MC68153 control register 1
Offset 5
D08/D16 MC68153 control register 2
Offset 7
D08/D16 MC68153 control register 3
Offset 9
D08/D16 MC68153 vector register 0
Offset B
D08/D16 MC68153 vector register 1
Offset D
D08/D16 MC68153 vector register 3
Offset F
D08/D16 MC68153 vector register 4
Offset 11
D08/D16 MC68153 Command register 0
Offset 13
D08/D16 MC68153 Internal event register 1
Offset 14
D08/D16 MC68153 D32 longword high order time read and freeze release
Offset 15
D08/D16 FIFO Data read
Offset 17
Not used 1
Offset 18
D32 longword time freeze ad low order data
Offset 19
D08/D16 Status Register
Status Bit 0
“0” FIFO not empty, “1” FIFO empty
Status Bit 1
“0” input code amplitude <500mV pk/pk, “1” Input code amplitude> 500mV pk/pk
Status Bit 2
“0” Synchronization error, “1” Good synchronization
Models TPRO-VME and TSAT-VME Q Synchronizable Timecode Generators
Edition 1.4