Download E5EZ-PRR

Adjustment Level
Adjustment Level
l. adj
MV When Stopped
“stop/error add MV” must be set to “ON”
MV During Error
●
●
“MV when stopped” refers to MV when operation has stopped (off/hold/on) .
“MV during error” refers to operation during error (off/hold/on) .
Functions
● Position proportional type
Setting Range
Settings
sprt
hold: hold/open: open/clos: close
Initial Value
none
hold
l. adj
SP ramp set point
●
Functions
Units
●
This parameter specifies the rate of change of the SP ramp. Allow each unit time
(min) maximum change width to be set to “SP ramp set point”. But note that when SP
ramp set point is set to “OFF”, SP ramp function is not effective.
With temperature input, the SP ramp set value’s decimal point is determined by the
sensor currently in use. During analog signal input, it is related to scaling.
Parameters
Setting Range
Units
Initial Value
SP ramp set value
OFF,1~9999
EU
OFF
Settings
●
Related parameters
“input type” (p. 5-21) , “scaling upper limit”, “scaling lower limit” “decimal point ”, (p. 522) .
Reference
5-17