Download User Manual - e-catalog
Transcript
Relevant for North America: For use in Class 2 circuits. Only use copper wire/conductors of class 1, 75 °C or 90 °C (167 °F or 194 °F). Relevant for North America: For use in Class 2 circuits. The device may only be connected to a supply voltage of class 2 that fulfills the requirements of the National Electrical Code, Table 11(b). If the voltage is being supplied redundantly (two different voltage sources), the combined supply voltages must fulfill the requirements of the National Electrical Code, Table 11(b). Relevant for North America: Adapters for BAT-F types providing field wiring means you obtain from the manufacturer. For field wiring, use a type E12AAA5A1A power supply cable, manufacured by Belden. Shielding ground The shield of the connectable twisted pair cables is connected to the metal casing of the device as a conductor. Beware of possible short circuits when connecting a cable section with conductive shielding braiding. Housing Only technicians authorized by the manufacturer are permitted to open the housing. Make sure that the electrical installation meets local or nationally applicable safety regulations. Warning! Never insert sharp objects (small screwdrivers, wires, etc.) into the inside of the product. There is the risk of an electric shock. BAT-F types: A separate screw connector on the housing is provided for the functional ground (FE). This is indicated by the functional ground symbol ( ). The functional ground is electrically connected to the switching ground and the metal housing of the device. BAT-Rail types: The lower panel of the device housing is grounded by means of the DIN rail. If installed in a living area or office environment, the device must be operated exclusively in switch cabinets with fire protection characteristics according to EN 60950-1. 6 BAT Family Release 03 08/10