Download S134H Basic Apparel Management

Transcript
Handout C
Make A-Mends
Hemmed-In
Supplies Needed:
• Basic sewing kit, thread, needle, pins
• Iron and ironing board or towels
• How To Replace a Button handout
From the sewing kit, select thread that matches the garment fabric as closely as possible.
Refer to the handout How To Replace a Button for how to thread the needle and knot the
thread ends.
Hand or Inconspicuous Machine-Stitched Hems
Repairs can be easily made to loose or missing hand stitches by following these steps:
• First, remove only the broken or loose stitches by
carefully pulling stitches out on each side of the
broken section. Figure 1
• Secure each side by threading a needle with the
“pulled” stitches and knot to keep remaining
stitches from loosening. Trim away excess thread
above the knot. Figure 2
• Re-sew missing hem stitches using either
hemming stitch or catch stitch. Figure 3
Hemming Stitch
Stitches are made from right to left. On
wrong side of fabric, secure end of thread
and bring needle and thread through the
hem edge. Directly behind this point, catch
only one thread from garment fabric. Direct
the needle to go diagonally to the left about
#4
1/4" and pull needle and thread through hem edge. Repeat until hem repairs are complete.
Figure 4
Prepared by:
Marla Day, Extension
Associate, Apparel, Textiles, and Interior Design,
Kansas State Research and Extension
5
• Kansas State University Agricultural Experiment Station and Cooperative Extension Service •