Download Cerberus User Guide

Chapter 13: Using the Well Editor
3. Click Set.
4. Enter the other well data.
This data includes location, depth reference point information for the well, the height, and any Comments.
Height refers to the distance between the reference point and the zero (0) depth of the well.
Well Editor General Tab
Configuring Subsea Information
Subsea wells present specific configuration requirements. Wireline subsea wells may be riserless.
To configure subsea wells
1. In Well Editor, select the General tab.
If the well is new, launch the Quick Well utility (see “Using Quick Well” on page 313); select Subsea as the
Location.
2. For the Location field, select Subsea from the dropdown.
a. If the project is a Wireline project, the well may be riserless. If this is the case, click (to check)
Riserless (this field is located adjacent to the Location field).
The Riserless option should be available for selection for a Wireline project in Quick Well.
3. Input or edit the Riser geometry.
a. If the well is Riserless, use the default values for new wells (already present), or input the Ocean
density, Ocean viscosity, and Ocean current data.
4. Save the Well information.
314
NOV CTES
Cerberus 11.0 User Guide