Download Universal Air-Conditioner Remote

Setting Up - Auto Search
Special Instructions
• Make sure that the air conditioners infrared remote signal receiver is working correctly. If
1. Turn on the power to your air condi
tioner at the main unit. Then point the
RS10 controller at the unit.
2. Press the “SET” button repeatedly until the
air conditioner receives a signal from the
controller. Normally indicated by a beep
sound. Then press the “OK” button to confirm
and set the correct code. Your RS10 remote
is now ready for use.
it is not in working order this controller will not function correctly.
• Using this controller will not increse the functions of your existing air conditioner.
For example: If your air conditioner does not currently have air swing control the air swing
button on this controller will not function.
• Do not mix different types of batteries together.
• If the electrolyte in the batteries should leak, wipe the contaminated area with a dry cloth
Air-Conditioner
Remote
and replace with new batteries.
• To prevent the electrolyte from leaking, remove the batteries from the controller when
planning not to use the controller for extended periods.
er
ion
dit e
on ot
-C em
Air R
Code Table
REMOTESPIRIT
Setting Up - Manual Search
1. Refer to the “Code Table” and locate
the correct code for your brand of air
conditioner. Example below: (BRAND) =
TOSHIBA / (CODE) = 56,57 Then turn on
the power to your air conditioner at the
main unit and point the RS10 controller at
the unit.
2. Repeatedly press the set button until
the code for your air conditioner is
flashing on the LCD screen
3. When the correct code is displayed
press the “OK” button to confirm and set
the code. The code will now stop
flashing.
4. Your RS10 remote should now be ready
for use. Check for correct operation of the
remote. If it is not working correctly repeat
steps 2~4 until correct code is located.
CONIA
flashing
Other Brands
er
ion
dit e
on ot
-C em
Air R
The code will stop flashing
If you are unsure of the brand of your air conditioner please use the Auto Search method.