Download drivemaster2 - SIEB & MEYER AG

Transcript
W
Parameters of an SD2x
Low-pass 1./2. order
A low-pass is used to suppress noise in the reference current value. This noise is
created e.g. by noisy speed measurement. By means of the low-pass losses in the
power output stage and in the motor can be reduced.
You can use a low-pass 1. order or a low-pass 2. order with Butterworth characteristic.
Set the desired filter and enter the 3 dB cut-off frequency of the filter. The unit is hertz.
Please consider that a low-pass in the reference current value reduces the
dynamics of the current control. For this reason you must possibly adapt the
control parameter of the speed controller (reduce the amplification and
increase the integration time).
Band-stop filter
A band-stop filter is used to suppress resonance frequencies caused by the mechan‐
ical construction of the driven machine.
Enter the center frequency of the band-stop filter. The bandwidth is set automatically.
The unit is hertz.
Please consider that a band-stop filter in the reference current value can
reduce the dynamics of the current control. For this reason you must possibly
adapt the control parameter of the speed controller (reduce the amplification
and increase the integration time).
Current Controller (SD2x, SVC)
SERVO /
VECTOR (SVC)
HSPWM
HSBLOCK /
FPAM
HSPAM / VF
✔
‒
‒
‒
On this page you can set the parameters of the current controller for SVC operation.
These are the current limitation, the holding current and the bandwidths.
Fig. 50: Parameter page "Current controller"
drivemaster2 - User Manual
143
10