Download HQ Pro-Stitcher User Manual

5. Make adjustments to the placement of the blue
rack as necessary to align the blue rack with the
front white gear on the HQ Pro-Stitcher carriage
(Figure 4).
6. If alignment using the wooden block is accu-
rate, continue using the wooden block as a guide to
mount the remainder of the blue rack to the table
top. Otherwise, use the carriage as a guide and align
the blue rack with the white gear along the length
of the table, removing the pink protective layer and
pressing downward on the blue rack while moving
down the entire length of the table top.
7. Trim the rack to length using a knife or wire cut-
ters if necessary (the blue rack does not necessarily
need to extend from Pro-frame arm to Pro-frame arm
and can actually be a couple of inches shorter
if desired).
Figure 4
8. At the ends of the blue rack, use the four small
metal clamps (Page 16 , B) to hold the ends firmly
in place (see Figure 5a). The clamps have a hole
through the center and a lip on one end. The lip
should be on the side opposite the blue rack. Drill
pilot holes using the 3/32” drill bit and then attach
the clamps as shown on either end of the blue rack
using a Phillips screwdriver. Note: Do not use the
larger drill bit included in the emergency repair
kit…this is the wrong size for the X-rack clamps! As
an alternative, choose to use one clamp at each end
using the lip of the clamp to slide over the last gear
of the blue rack (Figure 5b).
Lip
Figure 5 a
Lip
Figure 5 b
www.HandiQuilter.com/ProStitcher
Page 19