1
Download WCA230A & WCA280A Programmer Manual
Transcript
:SENSe Commands
[:SENSe]:CORRection[:STATe](?)
Determines whether to turn the amplitude correction on or off.
Syntax
[:SENSe]:CORRection[:STATe] { OFF | ON | 0 | 1 }
[:SENSe]:CORRection[:STATe]?
Arguments
OFF or 0 turns off the amplitude correction.
ON or 1 turns on the amplitude correction.
Measurement Modes
Examples
All S/A modes except SARTIME
:SENSe:CORRection:STATe ON
turns on the amplitude correction.
WCA230A & WCA280A Programmer Manual
2-399
