Download User` Guide RIGOL

RIGOL
Figure 2-53 Table 2-30 The Menu Explanations of the N-Cycle Parameters (Page2/2)
Function
Menu
Settings
Trig
Off
#Cycle
Explanation
Signal Triggered at Rise Edge
Signal Triggered at Fall Edge
Turn off Trigger Setting
Infinite
Set the Number of the bursts in a N-Cycle
Set the Number of the bursts in a N-Cycle
to be infinite
Delay
Set the Delay time before the burst starts
# Cycle
Set the number of Waveform Cycle in an N-Cycle (1 to 1,000,000 or Infinite).
If you choose Infinite, then a continuous waveform will be generated which will not
stop until a trigger event happens (Trigger button is pressed).
 If needed, Burst Period will increase to cater to the specific number of cycles.
 For a frequency greater than 25MHz, only a bust with infinite cycles is allowed.
 For an infinite-cycle Burst, External or Manual Trigger is needed to activate burst.
Delay
Set the Time Delay between the Trigger Input and the Start of the N-Cycle Burst. The
minimum delay is a function of the specific burst period, and should always be
greater than 0s.
2-46
User’s Guide for DG3000 Series
© 2006 RIGOL Technologies, Inc.