Download DMP2831_User_Manual

Chapter 5 -Pattern Printing
57
The following is a close-up of the cartridge angle alignment scale set to 0 degrees. The
outer main scale is in one degree increments. There is a notch on the 0 point of the inner
vernier scale is lined up with the 0 on the outer cartridge angle scale.
Inner Notch
Figure 5 - 17 Cartridge Alignment scale
The following picture shows how to set the cartridge angle to 11.4 degrees. The 0 notch on
the inner vernier scale is a little past the 11 degree mark. The next inner mark on the
vernier that is lined up with a mark on the outer ring is line 4. This gives 11.4 degrees.
FUJIFILM Dimatix, Inc. Confidential Information
Doc. #PM000040 Rev. 04
January 6, 2010