Download Using Time Division Multiplexing to support Real

Transcript
maximum data payload size for the Ethernet frame is 1500 bytes.
For the experiment, we consider packet transmissions from a UDP based application. The minimum data size for a UDP application will be 46 - 20(IPv4 header) 8 (UDP header) = 18 bytes. Similarly the maximum data size will be 1500 - 20 - 8 =
1472 bytes. Table 5.1 gives the theoretical transmission times for an UDP application
of varying data sizes over 10Mbps and 100Mbps Ethernet.
Size of Data
(in bytes)
upto 18
64
128
256
512
1024
1472
Total Packet Size
(in bytes)
64
110
174
302
558
1070
1518
10Mbps Ethernet
(in s)
51.2
88
139.2
241.6
446.4
856
1214.4
100Mbps Ethernet
(in s)
5.12
8.8
13.92
24.16
44.64
85.6
121.44
Table 5.1: Theoretical Transmission times for 10Mbps and 100Mbps Ethernet
The experiment setup consisted of two 500MHz machines running the KURT-Linux
kernel, without any modifications to the network stack. The machines were connected
through a hub. In order to determine the transmission time, DSKI instrumentation
was used to collect histograms, measuring the time difference between two successive
reception of packets in the destination machine. A stream of about 400,000 packets
from an UDP application was transmitted from the source machine to the destination
machine. The experiment was carried out for both 10Mbps and 100Mbps Ethernet
with varying message sizes. The average transmission times measured for the varying
message sizes are presented as histograms.
Figures 5.1, 5.3 and 5.5 display the histograms for the packet transmission times
in a 10Mbps Ethernet. Figures 5.2, 5.4 and 5.6 display the histograms for the packet
transmission times in a 100Mbps Ethernet.
From the results shown in Table 5.2, it can be seen that the observed average transmission times for packets in a 10Mbps Ethernet are in agreement with the theoretical
values. In case of the 100 Mbps Ethernet, it can be seen that the average transmission
53