1
Download Nexus LED Driver and Interface Module. Pulse Counter Interface
Transcript
Digit address and data byte organisation The unit can drive up to 3 master boards and three slave boards making a total of 12 seven segment displays. Digit 0 is the right hand digit, digit 11 is the left hand digit (assuming a 12 digit display). The count input port is connected to the 6 way 0.1 inch pitch connector on the right hand end of the interface board. Connections are as follows Pin Number Function 1 2 3 4 5 6 0 volts signal Count enable (1=enable) +5 volts for external pull ups (4k7 source resistance) Reset input (active low with internal pullup) Count Input (rising edge clock) Up/Down (1=up 0=down) Table 1 Relay/high speed input select jumper is up for relay and down for TTL pulse.Note if relay is selected and a high speed count applied the display will "freeze" and incorrect counting will occur. Nexus Machines Ltd reserves the right to alter or withdraw the product specification and characteristics without prior notice at any time in line with product development. Nexus Machines Ltd sole and exclusive warranty is that stated in the warranty article of the conditions of sale. Although every effort is made to ensure this data is accurate no liability is accepted for errors or ommisions that may affect the end product.
