Download TIMER S4 - Alge

TIMER S4
Page 36
Start:
A start impulse starts the clock (banana socket (19); channel 0). It prints "SZ" (start time), time of
day, and "0:00.00" on the P4 printer.
Finish- or Intermediate time-Impulse:
You can connect up to 16 impulse devices to make intermediate- or finish time impulses (e.g.
photocell RLS1c, Handswitch). It prints for each impulse the continuous ID number (4-digits), the
channel number, time of day, and net time.
Lap time or Time-out:
An impulse from channel 9 (banana jack 18) makes a lap time or time-out (depending on set-up
of options, see page 18, chapter 2.6.3.)
Reset of the clock:
-
press the red and yellow button (6+7) at the same time
the display shows on toggle switch position "C-timer" "0:00.00"
the course is ready for the next competitor or race
Pre-adjustment of the options:
dF-20
dS-1.0
SLP 5.0
SE nod
nET AUS
LZE EIN
LF CH1-2
SEC AUS
TAU EIn
HUn AUS
AUT EIn
Pri 6.0
Lr 0
finish-delay time = 0.2 seconds
start-delay time = 1 second
duration of displaying on display and display board = 5 seconds
lap timing for channel 9 (banana jack 18)
interface "display board" (14) transfers only time of day or net time
running tenth seconds are off
running time for display board interface is on channel 1 and 2
speed of output for display board interface = 0,1 seconds
precision is 1/1000 seconds
precision is 1/1000 seconds
display automatic is on
printer speed for Printer P3
printer prints in every line
Printer P4:
SZ
0001
K11
0002
K3
0003
K10
Version: E-06-04-18
10:00:00.000
0:00.000
10:00:32:323
0:32.323
10:00:32.495
0:32.495
10:00:33.023
0:33.023
-
time of day from start
all times are printed automatically
it prints for every impulse first the
time of day and then the net time
each impulse is printed with a continuous ID
number (4-digits)
SZ means start time (channel 0)
K means channel, the number following the K is
the channel number
Page 36