Download User Manual PDF

Complete Wiring Diagram
71
NOTE :
Complete Wiring Diagram is attached on this page.
VEHICLE STARTING PROCEDURE
Basic Guidelines to be followed “FOR ALL ELECTRIC START VEHICLES”
1.
When ignition key is switched “ON”, please wait until the malfunction indicator lamp (MIL) goes
off, before attempting to start.
2.
In cold condition of the engine or for initial start, it is advised to use electric start (ES) only.
3.
Apply choke in cold start condition. (ambient temperature <25°C)
4.
DO NOT ATTEMPT – “HALF START” BY CASUALLY PRESSING ELECTRIC START BUTTON.
5.
PLEASE PRESS AND HOLD ELECTRIC START BUTTON FOR ATLEAST 3 SECONDS
CONTINUOUSLY FOR THE CRANKING OR UNTIL THE ENGINE FIRES AND SUSTAINS,
WHICHEVER IS EARLIER.
6.
If engine doesn’t start in the first attempt, release the ES button and repeat the above procedure.
7.
It is advised not to apply excessive throttle during starting.