Download See it here - John Marcy

Transcript
Assembly Procedures
The Gantry ships assembled and consists of
a linear slide and motor. Be careful when
handling the Gantry. The box packed with
the Gantry contains all hardware necessary
for installation.
INSTALL THESE
2 LAST
Install two of the larger bolts into the bottom two holes in the Top Rear extrusion
from inside the tanning area. Leave them
protruding out about 1/2”. Stand the Gantry
vertically, with the motor at top, and hang it
on the two bolts. Install bolts into the other
two holes to secure the top of the Gantry
but leave the four bolts a bit loose. Leave
the bottom of the Gantry unsecured at this
time.
INSTALL THESE
2 FIRST
LEAVE LOOSE
25528-02A
34