Download User Manual

3-22
Configuring the Terminal
PanelView 1000 Grayscale -Screen Setup
SCREEN SETUP
Screen
Saver
Video
Mode
Off
Normal
Reset
Video
F1
F2
F15
SCREEN SAVER
Timeout
Intensity
10 min.
0
F9
F10
EXIT
F16
Note: Certain settings may make viewing the screen difficult. Do not
exit this screen until viewing adjustments are acceptable.
Video Mode [F2]
Toggles between normal video (darker text/graphics on a light
background) and reverse video (lighter text/graphics on a dark
background). The change takes effect immediately. Normal video is
recommended.
Screen Saver Mode [F1]
Sets the screen saver to Timed or Off. When Timed, the screen
intensity is reduced if user input or a controller screen change is not
received within the time specified in the Screen Saver Timeout box.
Screen Saver Timeout [F9]
Specifies when an inactive screen enters screen saver mode. The
timeout is adjusted in 5 minute increments with each key press, from
5 to 30 minutes.
Screen Saver Intensity [F10]
Adjusts the intensity of the display during screen saver mode.
Settings are 0 (lowest intensity) or 100 (highest intensity). 0 is
recommended to prolong the display life.
Reset Video [F15]
Resets the display to normal video (default settings).
On keypad terminals, the [F15] key is also active on the
Configuration Mode menu. If the screen is non-viewable, press the
Left and Right arrow keys simultaneously. Then press [F15] to
reset the screen.
Exit [F16]
Returns to the Configuration Mode menu.
Publication 2711-6.1