Download PXM 2000 Series (PXM 2250/2260/2270) Multifunction Electricity

Setup on the Web Server Pages
In addition to setpoints and alarm messages, you can also set the hysteresis. This is set
as a percentage, and is used to dampen “noise” events caused by a value bouncing back
and forth across a set point.
Out of Limits Setup Edit Page
Alarm on Value
Use the Alarm on Value Setup page to configure device, option card, or communications status event triggers. You can configure if such events are to be treated as alarms,
what the alarm levels are, the messages associated with the events, the limit values, and
if the alarms are to be autoclosing. These alarms include:
• Restart is pending
• Modbus RTU communications failure
• Alarms based on the state of digital inputs.
10-6
IM02601001E
www.eaton.com