Download MELSEC-L CPU Module User`s Manual (Function Explanation

Transcript
CHAPTER 3 CPU MODULE FUNCTIONS
3.30
CPU Module Change Function with SD Memory Card
This function enables to pass data from a module to be changed (disconnected) to the newly-connected CPU module.
By using this function, control can be continued after replacing a CPU module. To pass data, backup the data to an SD
memory card before replacing a CPU module, and restore them in the newly-connected CPU module before replacing
a CPU module.
3
LCPU
1) Back up data to
an SD memory card.
Program memory
Standard RAM
Standard RAM
Device data
SD memory card for storing backup data
3) Restore the backup
data.
System data
2) Change the CPU
module.
Programming tool
Only one backup data file can be stored to an SD memory card. If any backup data file exists in the SD memory
card, the file data are overwritten.
To delete the backup data file, select "Delete PLC Data..." of a programming tool.
(2) Backup data
(a) Backup data selection
Select a drive to back up from the following table.
Backup data (drive)
Description
Program memory (drive 0)
All data in the program memory (drive 0)*1
Standard RAM (drive 3)
All data in the program memory (drive 3)
Standard ROM (drive 4)
All data in the program memory (drive 4)
Device
data*2
Internal user device (L, B, F, V, T, ST, C, D, W)
System data
Data managed by the system (such as module error history)
*1
*2
Backup by user
Allowed
Not allowed (backed up by the system)
Data in the program cache memory are backed up.
Latch devices or devices set in the latch range are backed up.
169
3.30 CPU Module Change Function with SD Memory Card
(1) Backup data file